Bissell CleanView Power Trak BAGLESS REVOLUTION 6591 Series User Manual page 12

O Grasp Rotating Floor Brush at both ends and lift.
Clean stnngs, hair and other debris from Rotating Floor
3rush, paying [)articular aEentlon ro orusn ends.
O Clean strings, hair and other debris from Motor Pulley and
Drive Belt areas.
O Check Drive Belt carefu y for wear. cuts or stressea areas.
_ Check Air Passageway for obstructions. Remove debris
from this area.
\
Unplug cleaner from electrical ouue[.
AWJth Rotating Floor Brush removed from vacuum cleaner
v
(Steps 1-4 of check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove from Motor Pulley.
3iscard old Drive Belt.
@ ;lace new Drive Belt over Motor Pulley aoa s[re[cn otner end
over Rotating Floor Brush in the spacebetween the bristles.
Place ends of Rotating Floor Brush do_ n into slots on
sides as shown.
OTurn Rotating Floor Brush by hand severa times in the
direction of Motor Pulley. If properly installed Drive Belt
will center itself on Rotating Brush crown.
ReposJtion Brush Coverandscrew or snap back into place.
Checkto be sure all screws or latches are secure.
g
AirPassageway
Unplug cleaner from electrical outlet.
Using a screwdriver, remove the two screws as shown
and lift off the lens.
Remove the bulb from the socket by grasping bulb and
pulling straight out. Install the new bulb by pushing it
gently into the socket until the bulb snaos into place.
ReposJtionlens and secure with the two screws.
\\
_Lz .... eJ
0
Select ModelsOnly
TheTurboBrush shouldbe checkedregularlyfor clogs
or debriswrappingaroundthe brushroll.
Unplug vacuum from electrical OUtlet.
If a clog is present or debris is visible, unscrew [ne two
screws on the back of the TurboBrushto remove tne
faceplate and clear any obstructions.
O To clean debris from the brush rol, remove me screw
located by the brush roll with a Phil os head screwdriver.
_ift the belt cover. Remove the brush ro from the drive
belt and clean debris.