Table of Contents
Advertisement
MRWT40RGB
Installation
1)
Unpack and disassemble the clamps from the speakers. Make sure you account for all
hardware when removing it from the clamps. There are lock washers that must be re
-
installed on the clamps.
2)
Determine the location of the speakers.
3)
Determine the correct rubber clamp adapters that are needed for your application.
4) The rubber adapters will need to be cut to length, so they fit the enclosure and clamp.
5)
After the rubber clamps have been cut, remove the white protective layer and stick
them to the clamp and enclosure.
6)
Place the speaker on the tower and have the top clamp ready to place on top.
7)
Screw the two bolts evenly, until snug. Once the position is verified, tighten the bolts
another half-turn. DO NOT OVERTIGHTEN!
8)
The speakers accept up to 16 ga. wire, it is recommended you use a high-quality marine
grade speaker cable for your installation.
T
T
i
I
!
I
I
I
I
i
-
1
1
I
I
I
!
--==
Advertisement
Table of Contents
Need help?
Do you have a question about the MRWT40RGB and is the answer not in the manual?