Table of Contents
Advertisement
It is strongly recommended that you work with an assistant to install these speakers.
Installation instructions
STEP1
To adjust the mounting angle, loosen the metal
base of the mounting band by unbolting the two
screws.
Make sure to put all components of the mounting
hardware in a safe location.
STEP3
Place a supplied rubber (48 x 30 mm) pad on the
metal base of the mounting band to prevent
abrasion and secure clamping.
Metal base
48 x 30mm rubber pad
5.25" (133 mm) 2-Way Marine/Powersports
Roll Cage/Waketower Speaker Pods
STEP2
Twist the metal base to determine the
optimal mounting angle for the speaker on the
cage bar. Then secure the metal base
by tightening the two screws.
STEP4
Place two supplied rubber strips around the cage bar
to prevent abrasion and secure clamping.
Then push two supplied aluminum bands over the
cage bar, and align the aluminum bands with the
metal base on the speakers.
MPWT50RGB
Metal base
Aluminum band
Rubber strip
Mounting cage bar
(part of your marine
boat or powersports
vehicle)
Advertisement
Table of Contents
Need help?
Do you have a question about the MPWT50RGB and is the answer not in the manual?