Table of Contents
Advertisement
5.5 Installation the whole Charger
•
Install the charger into the rear plate from top to bottom, aligning it with the mounting bracket and the mounting holes.
•
Use a screwdriver to secure the mounting bracket to the location where it connects with the rear plate.
5.6 End and check
•
After completing the installation steps mentioned above, you also need to perform the following tasks:
•
If the charger does not come with parts for mounting the gun cable, install the necessary parts according to the installation
situation.
•
Secure the cable in place using cable ties or other suitable methods.
•
Site Cleaning: Dispose of site debris, garbage, and charger packaging boxes correctly after installation. The factory test
report, user manual, and user RFID card should be properly retained by the user.
6. Charger power supply operation
6.1 Power on operation
•
Before powering on the charger, ensure that the following steps have been completed:
•
Ensure that the procedures for charger installation have been executed correctly.
•
Inspect the electrical wires for leakage or incorrect connections to prevent power accidents.
•
For safety reasons, it is recommended to power on the charger with the presence of professional personnel.
•
Connect the cable to AC power supply network.
Installation schematic diagram of the support hanging ear installation
D
A
B
C
Mounting rear plate fixed to the wall
D
18
M4 x 10 screw
Mounting Screw
Mounting bracket
Charger main body housing
Advertisement
Table of Contents
