Table of Contents
Advertisement
Functional requirements
The following prerequisites must be met for
the system; otherwise, reliable notification of a
tire pressure loss is not assured:
▷
After each tire or wheel change, the system
detects and updates the mounted tires on
the control display and displays them after
a short trip.
Enter the information about the mounted
tires in the tire settings when the system
does not automatically detect the tires.
▷
The Tire Pressure Monitor does not acti-
vate until after driving for a few minutes:
▷
After a tire or wheel change.
▷
After a reset, for tires with special ap-
proval.
▷
After changing the tire setting.
▷
For tires with special approval:
▷
After a tire or wheel change, a reset was
performed with the correct tire inflation
pressure.
▷
After the tire inflation pressure was ad-
justed to a new value, a reset was per-
formed.
▷
Wheels with wheel electronics.
Tire settings
General information
The information about the mounted tires can
be entered in the tire settings if the system
does not automatically detect the tires.
The tire sizes of the mounted tires can be
gathered from the tire inflation pressure details
on the vehicle or directly on the tires.
The tire details do not need to be re-entered
when the tire pressure is corrected.
For summer and winter tires, the tire details
entered last are stored. After a tire or wheel
change, the settings of the tire sets used last
can be selected.
Online Edition for Part no. 01405A89334 - VI/23
Wheels and tires
Changing settings
1.
"CAR"
2.
"Vehicle status"
3.
"Tire Pressure Monitor"
4.
"Tire settings"
5.
"Tire selection"
6.
"Manual"
7.
"Tire type"
8.
Select the tire type that is mounted on the
rear axle.
For tires with special approval:
"Other tires"
Observe further proceeding in the perform
a reset section.
9.
Select the maximum road speed that will be
used with the tires.
10.
"Save tire settings"
The measurement of the current tire inflation
pressure is started. The measurement prog-
ress is displayed.
Status display
Current status
The system status can be displayed on the
control display, e.g., whether or not the system
is active.
1.
"CAR"
2.
"Vehicle status"
3.
"Tire Pressure Monitor"
The current status is displayed.
Current tire pressure
The current tire pressure is displayed for each
tire.
The current tire inflation pressures may
change while driving or depending on the out-
side temperature.
MOBILITY
287
OwnersManuals2.com
Advertisement
Table of Contents
