Advertisement
C-Z284
[ FRONT PANEL FACILITIES
|
® This unit has an automatic tape type selector.
(4) CD DIRECT indicator
* Tapes can be played back on deck |; tapes can be played back
This lights when
CD DIRECT
is on.
and
ded on deck Il.
oy
T a g
Oa anders
©) SURROUND indicator
¢ Sound can be recorded as adjusted by the sound image controller.
*® Use a normal or chrome
position tape.
This lights when
SURROUND
& STEREO
WIDE is on.
(©) SMART OPERATION
buttons
Amplifier section
STANDBY:
When set to the STANDBY
position, the main power flow
is cut and the unit is no longer fully operational.
A minute
Press this button to listen to a CD without passing the signal through
flow of power
feeds the unit to maintain operation
sound quality adjustment circuits.
readiness.
When the STANDBY indicator is on, the unit is in
SURROUND & STEREO WIDE button
STANDBY.
By turning this switch ON, you can enjoy surround reproduction when
.
rear speakers are used.
in
@ REMOTE
SENSOR
window
By turning this switch ON, you can enjoy STEREO WIDE reproduction
'© SMART
OPER.
(OPERATION)
indicator
with greater left-right spread when rear speakers are not used.
This lights when smart operation is on.
NOTE:
It goes out after about 30 seconds.
© /n the case of monaural source, SURROUND & STEREO WIDE effects
cannot be obtained.
© SURROUND
& STEREO WIDE functions do not operate if CD DIRECT
is on.
56
Advertisement
