Noise Reduction Setting; Turbidity Unit Selection - Optex TC-Mi Instruction Manual

11
Press the button to input 300.
Press the button to increase the value,
and press the button to decrease the
value.
Press and hold the
the displayed value continuously.
12
Press the button to confirm signal output
response time setting and shift to Noise
reduction setting.
5

Noise reduction setting

Select the noise reduction function at Normal/Enhanced level.
Example) Change from Normal to Enhanced;
13 Select the cursor to Enhanced by the
button.
14
Press the button to confirm noise reduction
setting and shift to Turbidity unit selection.
22
Response Time
button to change
Response Time
Noise Reduction
Noise Reduction
Noise Reduction
6

Turbidity unit selection

300
The turbidity unit used by the Turbidity Checker can be changed according to
sec
specific standards or usage conditions.
•The default turbidity unit is NTU.
Caution
•This device has a calibration curve using formazin standard liquid.
•The measurement accuracy will not change if the turbidity unit is changed.
300
Unit
sec
N T U
F N U
度
(Example) To change the turbidity unit from NTU to FNU;

Normal
Enhanced
15
Normal

Enhanced
16
Normal

Enhanced
Description
EPA-compliant unit
ISO7027 compliant unit
Formazine turbidity unit or polystyrene turbidity unit in Japan
Use as required.
Press the button to select the unit to
FNU.
Press the button to confirm turbidity unit
and shift to Offset adjustment.
0.1234
NTU
UNIT
0.1234
FNU
UNIT
0.1234
FNU
23