Output Selection - Optex TC-Mi Instruction Manual

■The following table gives default settings and setting ranges.

Output selection

Self-Checking
Alarm level setting
Alarm timer setting
Signal output
response Time
Noise reduction setting
Turbidity unit selection
Offset adjustment
LCD contrast
adjustment
MODE：Modbus RTU 1
Digital communication
setting display
On the Signal output response time setting, press and hold the
2 seconds or more to reset to the default value.
And then press the button to confirm Signal output response time setting and shift to
Noise reduction setting.
On the Offset adjustment setting, press and hold the
or more to reset to the default value.
And then press the button to confirm Offset adjustment and shift to LCD contrast
adjustment.
18
Default Setting range
Self-Checking / Alarm
0.01 to measurement range upper.
OFF
Refer to page 14,
"Setting the DIP switch"
OFF
1 to 120 minutes
60 seconds 30 to 600 seconds
Normal / Enhanced
Normal
NTU / FNU / 度 / None
NTU
0.0000 -1.0000 to +1.0000
10 1 to 20
BAUD：9600
Refer to page 31
ADDR：001
"11 Digital Communication"
PARI：None
and
and buttons for 2 seconds
2 Output selection
Select the output function at Self-Checking/Alarm.
•The default output selection is Self-Checking.
•When Alarm output is selected, output is reversed.
On the measurement value display screen,
3
press and hold
more until beep sound is heard.
The output selection is displayed.
(Example) To change the output selection
from Self-Checking to Alarm.
4
Select the cursor to Alarm by the
button.
5
Press the
selection and shift to alarm level setting.
* When the output selection is Self-Checking,
shift to signal output response time.
buttons for
Beeps
button for 2 seconds or
Press and hold
button to confirm output
 Self-Checking
Alarm
OUTPUT
Self-Checking
 Alarm
OUTPUT
19