Radio Shack PRO-2035 Service Manual page 3

Programmable scanner
Hide thumbs Also See for PRO-2035:
Table of Contents

Advertisement

10% THD
35
35
30
5
28-55
1-3
1
30
30
25
Limit
±5
40
40
35
Nominal
±8
dB
45
dB
45
dB
40
mV
3
Channels/sec.
50
sec.
2
watts
1.3
dB
dB
dB
Unit
kHz
25-520 MHz
760-1000 MHz
1000.005-1300 MHz
25-520 MHz
760-1000 MHz
1000.005-1300 MHz
Volume control, set to its minimum, squelched
EiA RS-204-A
NFM andAM
3 kHz dev. at 1 kHz
60% modo at 1 kHz
100 IlV input
WFM
22.5 kHz dev. at 1 kHz
100 IlV input
Residual noise
Scanning speed
Scan delay time
Audio output power
Modulation acceptance
Signal to noise ratio
Channels of operation
Channel, frequency,
and mode displays
Receiving system
Power source
Jacks
Dimensions (HWD)
Weight
Any 1000 channels in any band combination
Liquid crystal display
Direct key entry digital-controlled synthesizer, superheterodyne
1st
IF
(609.005-613.5 MHz)
2nd IF (48.5 MHz)
3rd
IF
(10.7 MHz) tor WFM
3rd
IF
(455 kHz) for NFM and AM
AC 120 V, 60 Hz, 18 W
DC 13.8 V 10 W
Headphones, external speaker, tape out and "BNC" type antenna connector
3 1/2
x 9
1/8
x
8114
inches (90 x 232 x 210 mm)
70.5 oz (2 kg)
Note:
Nominal specs represent the design specs. All units should be able to approximate these-some will exceed
and some may drop slightly below these specs. Limit specs represent the absolute worst condition that still might be
considered acceptable; in no case should a unit fail to meet limit specs.
PRODUCT SAFETY NOTICE
Many electrical and mechanical parts in this chassis have special safety characteristics. These characteristics
often pass unnoticed and the protection afforded by them cannot necessarily be obtained by using replacement
components rated for higher voltage, wattage, etc. Replacement parts that have these special safety charac-
teristics are identified in this manual and its supplements; eJectrical components havlnq such features are identi-
fied by
&.
in the schematic diagram and the parts list.
Before replacing any of these components, read the parts list in this manual carefully. The use of substitute re-
placement parts that do not have the same safety characteristics as specified in the parts list may create shock,
fire, or other hazards.
- 3 -

Advertisement

Table of Contents
loading

Table of Contents