Chevrolet Colorado 2024 Owner's Manual page 205

Hide thumbs Also See for Colorado 2024:
Table of Contents

Advertisement

204
Driving and Operating
Rearward. Park Assist and RCTA
overlays are not available when
Underbody Split is selected.
{
Warning
Use Hitch Guidance only to help back the
vehicle to a trailer hitch or, when
traveling above 12 km/h (8 mph), to
briefly check the status of your trailer. Do
not use for any other purpose, such as
making lane change decisions. Before
making a lane change, always check the
mirrors and glance over your shoulder.
Improper use could result in serious
injury to you or others.
Surround Vision (360 Degrees)
If equipped, the Surround Vision system can
display various views surrounding the
vehicle in the infotainment display using
four cameras mounted around the vehicle.
The front camera is in the grille under the
front emblem, the side cameras are on the
bottom of the outside mirrors, and the rear
camera is in the tailgate handle.
The Surround Vision system can be accessed
by selecting CAMERA in the infotainment
display or when the vehicle is shifted into
R (Reverse). To return to the previous screen
sooner, when not in R (Reverse), press the
Home or Back button on the infotainment
system, shift into P (Park), or, while in D
(Drive), reach a vehicle speed of
approximately 12 km/h (8 mph). The vehicle
may automatically switch views when it is
shifted into another gear.
Available camera views:
.
Front/Rear Standard View
.
Front/Rear Top-Down View
.
Rear Bowl View
.
Front/Rear Side View
.
Hitch View
.
Surround View
.
Guidance Lines
.
Hitch Guidance
Underbody Camera
There are two cameras underneath the
vehicle that show a view of the areas
underneath the front and rear bumper. This
feature is activated through the
infotainment display.
The cameras can be washed by the
following procedure:
1. Touch CAMERA on the infotainment
display.
2. Select the front or rear underbody
camera view.
3. Touch the symbol on the lower-left of
the infotainment display to activate the
washer.
If there is excessive or dry debris on the
shield in front of the camera lens, the
activated washer may not effectively clean
it. A manual cleaning may be necessary.
Excessive or prolonged use may cause
damage to the shield. Periodic service or
replacement may be required.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents