Table of Contents
Advertisement
PROGRAMMING
CONTROLLER SETTINGS
Pressing the setting button will cycle through the controller's available settings:
kPa, and LEAF OFFSET.
°F/°C SETTING
Changes the displayed units to Fahrenheit
or Celsius. Press the up or down button to
cycle through F and C. All displayed units will
automatically convert when adjusting this setting.
CALIBRATION TEMPERATURE SETTING
Adjusts the temperature reading the sensor
probe is measuring. Press the up or down button
to increase or decrease the data figure in 1°
increments. The calibration cycle ranges from
-20°F to 20°F (or -10°C to 10°C) and will be
applied to the sensor probe's measurements.
°F / °C, CALIB. T° / H% /
Screen shown: CLOUDFORGE T3
Screen shown: CLOUDFORGE T3
31
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CLOUDFORGE and is the answer not in the manual?
Questions and answers
Can I have clear instructions on how to set my machine to keep my environment to 60% humidity please, cloudforge t3 gen 2
To set the AC Infinity Cloudforge T3 Gen 2 to maintain 60% humidity, follow these steps:
1. Access the Smart Controls: Use the controller or app connected to the humidifier.
2. Set the Target Humidity: Adjust the target humidity level to 60%. This ensures the unit will maintain that level.
3. Enable Auto Mode: Use the auto mode to allow the humidifier to turn on and off as needed to maintain the set humidity.
4. Check Settings: Confirm there are no hidden triggers, automations, or faulty settings that could override the target humidity.
This setup ensures the humidifier operates efficiently and maintains the desired 60% humidity level.
This answer is automatically generated
my ac infinity Cloudforge T3 gen 2 humidifier display keeps saying water level is low even when filled to top
The AC Infinity Cloudforge T3 Gen 2 humidifier may display a low water level alert even when filled to the top if the water tank is lifted or not properly seated. Lifting the tank triggers the alert, which disappears once the tank is correctly placed back into position.
This answer is automatically generated