GE Monogram ZV950 Owner's Manual page 8

The Problem Solver
Slair_less Steel Hood
Questions ?
Use this
problem
solven t
PROBLEM POSSIBLE CAUSE
FAN DOES NOT • A fllse Inav be blown or a circuit breaker tripped. Replace fllse or
OPERATE WHEN reset circuit breaker.
THE SWITCH IS ON
FAN FALLS TO • Fan blade striking the hood shell.
CIRCULATE AIR • Excessively soiled filter should be checked and corrected befl)re
using the hood again.
FAN OPERATES BUT • Check to be sure the filter is clean. If replacing the filter does not
MOVES AIR SLOWER correct the problem, call tot service.
THAN NORMAL
FAN KEEPS GOING
OFF AND ON
CL_N FILTER LIGHT
IS ON OR BLINKING
• The motor is probably overheating and turning itself off. This can
be hannflfl to the motor. Check to be sure the filter is clema. If ot1
and on cycling continues, call tot service.
• The filters have been in place tot 30 hours of "on" time. Remove the
filters, clean if necessarv and replace them. Make sure they are
correctly seated in the filter channels. A_!just as necessary until the
red signal light stops blinking. See the Metal g'*_a,sefille*i
( h,at_ filler li@t section.