Electrical Connecting - Gentech GP6500I Operator's Manual

ELECTRICAL CONNECTING:

9.2.
LOAD CAPACITY:
9.3.
*NOTE: Before use, the generator set and its electrical equipment (including lines and plug
connections) should be checked to ensure that they are not defective.
The generator set must not be connected to other power sources, such as the power
company supply mains.
Before connecting the electrical equipment, please follow the following steps to calculate the
starting power required for the electrical equipment:
Select the electric equipment running at the same time.
9.3.1.
The total operating power is the required power.
9.3.2.
Calculate the maximum starting power required according to the following steps:
9.3.3.
Calculate these numbers according to the steps required.

Fluctuation power is the extra surge power required for electric drive equipment.

Power Management
9.4.
Voltage and current power are converted by the following formula: Voltage x Current = Power
In order to extend the service life of the generator set, please refer to the following steps to increase
the power load:
Start the generator set without power load.
9.4.1.
Let the generator continue to run for a few minutes until stable.
9.4.2.
Turn "fuel saving" switch to "ON".
9.4.4.
Then plug in and run the first electrical device. It is better to allow the maximum power to be
9.4.5.
connected to the generator set first.
9.4.6.
Wait till the generator set is stable.
9.4.7.
Connect it to another electrical device.
9.4.8.
9.4.9. Wait till the generator set is stable.
9.4.10. Repeat step 6 and 7 until complete; and then turn on the connected electrical equipment.
*NOTE: Turn "OFF" the "fuel saving" switch before increasing engine speed.
Connecting One Generator to the Electrical Appliances:
9.5.
Start the generator set and keep running until it stabilizes.
9.5.1.
9.5.2.
Before connecting the electrical tools and equipment, determine the rated voltage of the generator
set {230V ac, 7A; 12V de, 8A) and ensure that there is enough current capacity to supply all
electrical equipment. If the power consumption exceeds the maximum power of the generator set,
connect the electrical equipment to the generator separately.
When the generating set is working, please connect the 230V AC power tool to the AC socket of the
9.5.3.
generator set and the 12V DC equipment to the 12V DC socket.
Do not connect three-phase electrical equipment.
9.5.4.
Do not connect the electrical equipment not recommended in the manual.
9.5.5.
Do not connect the load beyond the rated power of the generator set.
9.5.6.
Connecting Two Generators in Parallel to Electrical Appliances:
Two generators connected in parallel can increase the output power of the generator.
Please follow the below steps when connecting 2 generators in parallel.
*NOTE: Turn off both generators (engines) and disconnect all cables if any electrical appliances are
connected to the socket.
15