Advertisement
DOLBY PRO LOGIC SURROUND AND DOLBY 3CH LOGIC
Use with video or audio software bearing the
pia] [DOLBY 'SURROUND |
mark.
Use
DOLBY
PRO
LOGIC
SURROUND
when
rear
speakers
are
connected,
and
DOLBY
3CH
LOGIC
when
rear speakers
aren't
connected
For correct
surround
reproduction,
be sure to perform
following
adjustments.
| LEVEL ADJUSTMENT
1. Use SURROUND MODE buttons to select DOLBY PRO LOGIC
SURROUND or use the DOLBY 3CH LOGIC button to switch
DOLBY 3CH LOGIC ON.
Use SPEAKERS button to turn on front speakers.
Adjust MASTER VOLUME to a suitable listening level.
Press BALANCE 1 and R buttons together.
Select the CENTER MODE (NORMAL, WIDE, PHANTOM) setting
with the remote control CENTER MODE button.
oP
YN
6. Press the remote control TEST TONE button.
7. With the remote control BALANCE (L, R}, CENTER LEVEL (+, ~-),
and REAR LEVEL (+. -) buttons, adjust the test tone volume level
so that is the same from each speaker.
8. Press the remote control TEST TONE button to switch the test tone
OFF.
NOTE:
* The TEST TONE turns off if you operate the INPUT SELECTOR,
° CENTER MODE PHANTOM selection and REAR LEVEL adjustment
are not possible during DOLBY 3CH LOGIC operation.
|
OPERATION
1. Select DOLBY PRO LOGIC SURROUND
with the SURROUND
MODE buttons, or select DOLBY 3CH LOGIC.
2. Select the component for playback with the INPUT SELECTOR
buttons.
3. Select the center mode with the remote control CENTER MODE
button.
4. Begin playback.
5. Adjust volume level with the MASTER VOLUME control.
SETTING THE DELAY TIME
When using DOLBY PRO LOGIC SURROUND, you can set the delay
time between 16 ms and 30 ms. The standard setting is 20 ms, but
you can select any setting of your choice.
When you press the DELAY TIME button on the main unit or remote
control, DELAY TIME lights in the display section, with numerical
indication of the delay time.
Memorized tone settings can be recalled using the SELECT button. Up
to five different tone settings can be memorized.
Setting the Acoustic Memory
1. Adjust the sound quality as desired using the BASS and TREBLE
control buttons.
* Setting are shown by the TONE indicator on the display section.
2. Press the MEMORY button.
* The ACOUSTIC indicator on the display section blinks on and off.
3. Press the SELECT button and select the acoustic memory to which
you wish to assign the setting (A — E).
*® The sound
quality setting
is memorized
approximately
two
seconds after you last press the SELECT button.
26
<ARBIS78>
in this way, the desired tone will be preset in one of the five acoustic
memory positions. To preset four other desired tone settings, perform
the same operations.
Recalling tone setting in the Acoustic Memory
To recall the memorized tone settings, press the SELECT button to select
the desired memory position.
[Pe
ee
ee
a]
FLAT:
For flat (normal) frequency response.
LOUDNESS:
Emphasizes
the
low-
and
high-frequency
ranges.
Produces
a fuller sense of sound,
particularly when:
listening at fow volume,
:
A-—E:
Memorized acoustic memory settings.
Advertisement
