Rear Panel Connections - Creek Audio 4040 Instruction Manual

LINE OUTPUT
Left and right RCA sockets provide audio output to an amplifier. Connect a good quality RCA to RCA interconnect
cable from the output sockets to the Line input of an integrated amplifier or pre-amplifier, like the Creek 4040 A.
Adjust the volume level on the amplifier.
DIGITAL OUTPUTS
COAXIAL For the best performance, connect a 75 Ohm RCA to RCA digital audio cable from the coaxial output
socket to the matching coaxial digital input on the Creek 4040 A, or another D to A product.
OPTICAL Use the TOSLINK optical output for ground isolated connection to a separate DAC or 4040 A
integrated amplifier, with digital inputs.
AES-EBU Professional systems use balanced digital interfaces, using higher signal voltages, enabling longer
cables to be used. Balanced or symmetrical signals offer better common-mode-rejection of noise
and hum than unbalanced connections. Use an XLR to XLR - 110 Ohm interconnect.
TRIGGER enables the 4040 CD to wake up an amplifier when powered ON. It also enables another product,
like an amplifier, to wake up the CD Player.
IN Connect a 3.5mm MONO interconnect from the IN socket to a 12V output trigger on another device
to wake-up the CD Player from standby, when the other device is powered-ON.
OUT Connect a 3.5mm MONO interconnect from the OUT socket to an amplifier or other device to wake it
up from Standby when the CD Player is powered-on.
12V DC Connect the 3.5mm jack plug to the 12V POWER INPUT. Centre pin is positive.
UPDATE Software updates can be performed only from a PC computer running windows OS 10 via the USB-C
socket. The associated push button must only be pressed when performing an update. Check with
your dealer, or info@creekaudio.com.

REAR PANEL CONNECTIONS

Page:
5