Kenwood TM-201A Instruction Manual page 9

3. INSTALLATIONS AND CONNECTIONS
@ ANTENNA
The performance of the transceiver depends upon the type of antenna to be us-
ed. To ensure the maximum performance of the TM-201A, select a suitable
antenna and adjust it for low VSWR.
@ MOBILE INSTALLATION
e Interconnection The TM-201A is equipped with a speaker.
Y
JUULULUUU AI [
¢ Wiring on_ installation
+) Red + Red
a Fuse (20 A)
Engine compartment «—— H ———+ Passenger compartment
|
'Chassis or Fire wall
Select the location
where the power cable
is protected from heat,
moisture or abrasion
secure the cable.
Make sure the cable
does not directly con-
tact the edge of the hole
by using a grommet.
Notes:
© Before installing the power cable, be sure to remove the negative lead from the
battery for safety.
e After installation and wiring, be sure to double check for correct installation
before reconnecting the negative lead to the battery terminal.
° If the fuse opens, be sure to check that each conductor has not been damaged by
short-circuiting, etc.
Then replace with a new fuse of the same rating.
° After completing the wiring, wrap the fuse holder with tape to protect against
moisture.
* Do not cut out the fuse even if the power cable is too long.
@ If the wiring hole in the fire wall or chassis is too small, disassemble the fuse
holder to thread the wire through the hole.
From passenger compartment —=
a
The lead like this
® Installation location
a Using the supplied mounting bracket, install the transceiver under
the dashboard or on the side of the console in your car as shown.
| Console lf your car is equipped with an electronic fuel injector, the
ae uae a4 of transceiver should be as far from the control equipment as possible.
jashboar