Kenwood TM-201A Instruction Manual page 14

@ 16 key AUTO PATCH OPERATION (For U.S.A. version)
To operate, hold the mic PTT switch depressed until keys are started operating.
Note:
1. When the tone encoder is started operating, the transceiver is in transmit
mode even with the PTT switch released.
2. More than about 0.8 seconds keying interval restores the transmit mode
to receive mode.
3. The touch-tone encoder level can be readjusted according to your re-
quirement.
When readjusting, set the deviation to 3 kHz by the mic built-in VR with
both the 3 and 6 keys of the encoder held depressed. Next, hold both the
2 and 3 keys depressed to verify the deviation which is within
1.2 kHz+0.3 kHz.
@ VERIFICATION BEEP TONE
When operating, the beep sounds to indicate operation. Beep level can be ad-
justed by the potentiometer inside. (page 18)
Beep When beep will sound
Once When key operated correctly.
Twice When CH1 is busy during alert operation.
When ordering memory scan with all memory channels
Three times empty. When an offset frequency is out of operating
frequency range.
Four times When transmit frequency for odd split is not stored, the
repeatedly beep will sound until the frequency is stored.
Five times During REVerse operation
Eight times When memory is ready to be stored.
Once for approx. F
41 5i88c When memory is stored.
14