Kenwood TM-201A Instruction Manual page 16

(2) Programmable scan
144.5 &
144.0 Upper limit
Lower 146.0
limit For Europe and
England
148.0
For others
16
During VFO A or B operation, depressing the mic UP or DWN switch initiates
scan programmed within the range set between receive and transmit frequen-
cies designated in memory channel 5.
As shown in the figure, R denotes the receive frequency in CH 5; T denotes the
transmit frequency in CH 5.
i) When VFO stays at A point, scan starts as shown.
Up scan Down scan "
ii) When VFO stays at B point, scan starts as shown.
2
=
D
Up scan Down scan
iii) When R and T are equal, scan operates through the whole frequency
range.
Procedure Operation Indication
Store lower and upper limit frequencies in
1 | Scan range setting | memory channel 5 by operating the M, M5,
tuning control UP, DWN or MHz switch,
Hold the mic UP or DWN switch depressed for
more than one second. The scan starts. The dot Flashes
starts flashing.
3 | The scan will stop at busy station and resume in 6 seconds.
2 | Scan start <
Scan resumes regardless of signal when
4 | Scan resume operating the tuning control or UP/DWN
switch
Holding the UP/DWN switch depressed allows
rapid up or down scan.
Holding the MHz key depressed allows rapid
scan in 1 MHz steps
5 | Rapid scan
During up scan, depressing the DWN key or
turning the tuning control one click to the left
reverses the direction.
During down scan, reversing the above pro-
cedure reverses the direction.
6 | Scan direction
Holding the UP/DWN key depressed allows the
scan to go beyond the upper or lower frequency
limit.
Example: During up scan from R to T, hold
the UP key depressed and allow the
scan to go beyond T. The scan goes
from T to R.
7 Other scan range
operation
Depressing the A/B key or mic PTT switch
8 | Scan release releases the scan.