Kenwood TM-201A Instruction Manual page 7

@ REV switch Used to reverse the repeater shift (+600 kHz) to monitor a signal coming to a
REV repeater. Setting this switch to ON in simplex operation locks the displayed fre-
O quency regardless of VFO, keyboard, and COM*.CH operations. (* European
and British versions excluded.)
@ TX OFFSET switch Used to set transmit frequency (+600 kHz) shifted from the displayed receive
frequency when transmitting.
For operation other than that of a repeater, place this switch to the ''S'' posi-
fou tion. This equalizes the transmit frequency with the receive frequency.
aa "4+ setting shifts +600 kHz; ''—"' setting shifts —600 kHz from the
receive frequency when transmitting.
This operation is only effective in VFO and MR (M1~M3) operations.
If a shift frequency goes beyond the operating frequency range when depress-
ing the PTT switch to transmit, a beep will sound three times to indicate the
misoperation.
However, transmit frequency is emitted in simplex mode.
*With the optional TU-3 tone unit installed, either ''+'' or ''—"' setting of the
TX OFFSET switch interconnects the TU-3 2nd tone frequency setting.
(* European and British versions excluded.)
@ REAR PANEL
© ®
@ ANT connector lead Connect a 50-ohm antenna to this terminal.
@ DC Power Terminal DC power input terminal. Connect the supplied power cord with plug. Input
voltage is 13.8 V DC.
Observe plus (+) and minus (—) polarity!
@® SP Terminal Connect the supplied 8 ohm speaker to this jack.
@ RIGHT SIDE PANEL
@® Remote jack Used to connect the optional FC-10 unit, controlling the operation frequency.
7