Cleaning The Oven Cavity - Smeg Victoria TR90GR2 Manual

kitchen roll. In case of stubborn dirt, wash
with a damp sponge and neutral detergent.
7. When you have finished cleaning, reinsert
the intermediate glass pane in its housing in
the door.
8. To reposition the internal glass pane, slide
the upper part into the door strip and insert
the two rear pins into their seats by pressing
lightly.

Cleaning the oven cavity

In order to keep your oven in the best possible
condition, clean it regularly after letting it cool
down.
Avoid letting food residue dry inside the oven
cavity, as this could damage the enamel.
Take out all removable parts before cleaning.
For easier cleaning, it is recommended to
remove:
• the door;
• The rack/tray support frames.
In the event you are using specific
cleaning products, we recommend
running the oven at maximum
temperature for 15-20 minutes in order
to eliminate any residue.
Drying
Cooking food generates moisture inside the
appliance. This is a normal phenomenon and
does not affect the appliance's operation in any
way.
Each time you finish cooking:
1. Let the appliance cool down.
2. Remove any dirt from inside the appliance.
3. Dry the interior of the appliance with a soft
cloth.
4. Leave the door open until the inside of the
appliance has dried completely.
52 - CLEANING AND MAINTENANCE
Regenerating the self-cleaning panels (on
some models only)
The regeneration cycle of the self-cleaning
panels (catalytic cycle) is a cleaning method
that uses heat to remove light grease residues. It
does not remove sugar-based residues.
1. First clean the base and the top of the oven
cavity using a microfibre cloth soaked in
water and neutral washing up liquid. Rinse
thoroughly.
2. Set a regeneration cycle by selecting a fan
assisted function at the maximum
temperature for one hour.
3. If the self-cleaning panels are particularly
dirty after the regeneration cycle, remove
them and wash them with neutral washing
up liquid. Rinse and dry them.
Put the self-cleaning panels back in the oven
and use a fan assisted function at 180°C for an
hour to ensure that they are thoroughly dry.
We recommend carrying out the self-
cleaning panel regeneration cycle
every 15 days.
Removing self-cleaning panels and rack/tray
support frames (on some models only)
Removing the side self-cleaning panels and the
rack/tray support frames enables the sides to
be cleaned more easily. This should be done
each time the automatic cleaning cycle is used
(on some models only).
To remove the rack/tray support frames:
• Pull the frame towards the inside of the oven
cavity to release it from its groove A. Then
slide it out of the seats at the back B. The
side self-cleaning panel is attached to the
rack/tray support frame.
During the removal take care not to
detach the self-cleaning panel from the
rack/tray support frame accidentally to
avoid damaging the surfaces.
• After cleaning, repeat the above procedure
to put the self-cleaning side panels and
91477A390/A