Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual page 81

Steps
1. Place the power-supply unit on the chassis and slide it towards the back of the chassis.
2. Replace the three (M6-32) screws to secure the power-supply unit to the chassis.
3. Route the power-supply cables through their routing guides on the chassis.
4. Connect the power-supply cables to their connectors on the system board.
Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard drive
3. Install the 2.5-inch hard drive
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in
if applicable.
if applicable.
After working inside your
Ta bort och installera enheter som kan bytas ute i fält (FRU:er)
computer.
81