● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx #5 (T5) screwdriver
● Plastic scribe
Screw list
OBS:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
OBS:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
OBS:
Screw color may vary with the configuration ordered.
Tabell 25. Screw list
Component
M.2 2230/M.2 2280 Solid-state
drive
Hard-drive and optical-drive
supporting bracket (LOW)
Optical-drive supporting bracket
(LOW)
Serial/VGA module
DP/HDMI/Type-C module
SD-card reader
WLAN card
Processor-fan and heat-sink
assembly
Voltage regulator heat-sink
Power-supply unit
System board
Screw type
M2x3
#6-32
M2x3
M2x5
M3x3
M3x5
M2x3
Captive
Captive
#6-32
#6-32
Quantity
1
1
1
2
2
1
1
4
4
3
5
Screw image
Arbeta inuti datorn
35
Need help?
Do you have a question about the OptiPlex Small Form Factor Plus 7010 and is the answer not in the manual?
Questions and answers