Table of Contents
Advertisement
Model 5355A
Installation
SECTION II
INSTALLATION
2-1.
INTRODUCTION
2-2.
This section provides instructions for unpacking, inspection, preparation for use, storage,
and shipment of the 5355A plug-in.
2-3.
UNPACKING AND INSPECTION
2-4.
If the shipping carton is damaged, inspect the 5355A for visible damage (scratches, dents,
etc.). If the 5355A is damaged, notify the carrier and the nearest Hewlett-Packard Sales and
Service Office immediately (offices are listed at the back of this manual). Keep the shipping
carton and packing material for the carrier's inspection. The HP Sales and Service Office will
arrange for repair or replacement of your instrument without waiting for the claim against the
carrier to be settled.
2-5.
PREPARATION FOR USE
2-6.
Power Requirements
2-7.
The 5355A does not require external ac power. Ail necessary power is supplied by the5345A
when the 5355A Is plugged in.
2-8.
Operating Environment
2-9.
The operating temperature range is 0°C to 55°C. If these limits are exceeded at the
installation site, auxiliary cooling or heating should be used to keep environment within limits.
2-10,
Installation
2-11.
To install the 5355A, proceed as follows:
a.
On the 5345A, set POWER switch to STANDBY.
b.
Pull the locking handle on the left side of the 5355A up to the horizontal position.
c.
Slide the 5355A into the 5345A. Use caution to prevent damage to interface con¬
nectors at rear of unit.
d.
Push locking handle down and toward the Instrument until it is parallel with the front
panel.
e.
For operating Information, address switch settings, and connections to rear panel BNC
connectors, refer to Section 111.
2-12,
Compatibility with 5345A
2-13.
The 5345A must be in EXT GATE mode when the 5355A is in PULSE mode and must be in
INT GATE mode when the 5355A is in CW mode. If the GATE CONTROL switch on the rear panel
of the 5345A is left in INT position, then the proper gating mode is selected automatically in
5345A's that have Serial Prefix 1808A or higher. Older 5345A's with serial prefix 1744A and below
require manual selection of EXT GATE mode (for PULSE) and INT GATE mode (for CWl. However,
a minor modification can be added (see paragraph 8-13) which updates these units.
2-1
Advertisement
Table of Contents
