Installation; Introduction; Initial Inspection - HP 8511A Operating And Service Manual

3

Introduction

Initial Inspection

Table 3-1

Installation

This chapter explains how to install the HP 8511A test set. The topics
covered include initial inspection, environmental considerations, positioning
and connecting the test set for use, and packaging the instrument. Refer to
the "Installation" chapter of the HP 8510 On-Site Service manual for more
complete system connection and turn-on instructions.
Inspect the shipping container (including cushioning material) for damage.
If it is damaged, keep it until you have checked the contents for
completeness. The contents are listed in Table 3-1.
In addition, check the test set mechanically and electrically. If the test set and
shipping container are undamaged, passing the Operator's Check (in
Chapter 4, "Operation") should suffice for incoming inspection. If the test
set does not pass the Operator's Check, refer to the troubleshooting
procedures in the HP 8510 On-Site Service Manual or call your local HP
Customer Engineer.
If the shipping container is damaged or defective, keep the shipping
materials and notify both the carrier and the nearest Hewlett-Packard office.
The HP office will arrange for repair or replacement of the test set without
waiting for settlement of the claim. If the components received with the test
set are incomplete, notify your nearest HP office and the deficient parts will
be sent to you.
Contents of the HP 8511A Shipping Container
Item
Power Cord
Test set cable assembly
GPIB cable
Performance test software (CD-ROM) assembly
HP 8511A Operating and Service Manual
1
Semi-rigid cables (2)
1. For performance testing and operator's check.
Part Number
8120-1348
08510-60102
8120-3445
08511-60024
08511-90072
08510-20005
08510-20006
HP 8511A Test Set Operating and Service Manual 3-1