Table of Contents
Advertisement
Mode! 5355A
General Information
Table 1-1. Model 5355A Specifications (Continued)
5356A OPTION 001 HIGH PASS FILTER
SPECIFICATIONS
DEFINITIONS
Insertion Loss:
<1 dB from 1.5—18 GHz
LSD Displayed:
Unit value of least significant digit.
insertion Loss below 100 MHi: >35 dB
Resolution:
Maximum deviation (or rms deviation)
between successive measurements under
constant environmental and constant input
conditions.
GENERAL
Accuracy:
Deviation from the true value as fixed by
universally accepted standards for frequency
and time.
IF OUT:
Down converted signal in range of
80—375 MHz available at 5355 rear panel
IF OUT connector. 0 dBm NOMINAL level.
Minimum
ON/OFF Ratio:
For a pulsed rf input, the required minimum
difference, in dB, between the pulse ON signal
level and pulse OFF signal level which will
CATE OUT:
0 to -1 volt detected IF signal used to drive
enable the 5355 to distinguish a pulse input.
5345A EXTERNAL GATE CONTROL INPUT,
Width of CATE OUT is approximately 30 ns
less than rf burst width.
Maximum Video
Feedthrough:
For a pulse rf input, the maximum peak-to-
peak voltage caused by the superposition of
video components above 75 MHz, which the
PULSE OUT:
Detected IF signal: TTL levels; TTL low
5355/56 can tolerate in the burst.
indicates signal present; +1 to 0V TYPICAL
rms jitter =
1
I
V
into 50ft.
V(5345A GATE TIME) (EXT GATE WIDTH)
X = 100 Hz rms
Operating
0° to 55°C
For EXT GATE signals generated by the 5355A,
Temperature:
the EXT GATE WIDTH equals the input PULSE
WIDTH minus 30 ns (TYPICAL) for the
Weight:
5355A: 3.75 kg f8 lb., 4 oz.) net
5356A/B/C: 0.54 kg (1 ib., 3 oz.) net
5356A/B/C input and equals input PULSE
width minus 40 ns (TYPICAL) for the
5355 0.4—1.6 GHz input.
5356A/B/C
27.4 mm, 138 mm,56.6 mm (1.08 ,5.43 ,2.23 )
Dimensions:
Cable length: 1.68 metres (66"j
1-13.
SAFETY CONSIDERATIONS
"1-14.
This product is used as part of a Safety Class I instrument (provided with a protective earth
terminal). Safety Information pertinent to the operation and servicing of this instrument is
included in appropriate sections of this manual.
1-15.
EQUIPMENT SUPPLIED
1-16.
The only equipment supplied with the 5355A plug-in unit is the BNC Cable (HP Part No.
05355-60101) shown in Figure 7-7.
1-17.
ACCESSORIES
1-18.
Accessories available for use with the 5355A are as follows (connector and filter options
listed in Tabfe 1-2):
5356A Frequency Converter Head (1.5—18 GHz)
5356B Frequency Converter Head (1.5—26.5 GHz)
5356C Frequency Converter Head (1.5—40 GHz)
Extender Board Service Kit, HP Part No. 05355-60100 (See paragraph 1-19)
APC 7 to N(f) Adapter, HP 11524A
1-4
Advertisement
Table of Contents
