How To Connect - Denon DP-47F Operating Instructions Manual

1. Remove the packing material
Remove the packing material (styrofoam)
attached to both sides of the cabinet.
. Install the turntable platter and the turntable
mat
1) Insert the turntable platter onto the motor
shaft.
2) Place the turntable mat on the platter, align-
ing the size detection holes. For the pro-
truding sections of the turntable mat into
the outer square of the turntable platter.
Notes: ® Be careful not to scratch the magnet-
ic coating on the inner surface of the
turntable. Further, avoid touching
the diamond-cut (shiny) edge of the
turntable platter with hands, as this
may cause corrosion of the surface.
@ Automatic record size detection will
not function, if the size detection
holes on the platter and the mat are
not properly aligned.
HOW TO CONNECT
Align the square
Protruding section
on the reverse side
Turntable platter
insert the protruding
sections into the outer
square holes
Motor shaft
1. Connect the left (L) and the right (R) output
wires to the respective "PHONO" input termi-
nals of the amplifier to be used.
Further, connect the ground wire (which is
together with the output wires) to the "GND"
terminal of the amplifier.
Notes:
Although the auxiliary cartridge DL-80MC is
a moving coil (MC TYPE) cartridge, it can be
connected directly to the MM position of
the amplifier without step-up transformers
or head amplifiers.
U.S., Canadian & Asian models do not include
cartridge. See page 8 for mounting cartridge.
. Connect the AC power plug to an AC wall out-
let.
5
\— Power cord
AC wall outlet
Ground wire
A 9 a OO RD WS PT RT ORO EAL Lee eae, TE AL S ee P a