TOPRO Troja Original Instructions For Use Manual page 8

EN EN
SV
3 Unfolding / Folding
Unfolding: Release the lock clamp posi-
tioned at the seat bars (A). Press the seat
bars down and outwards. The side frames
will slide apart. Press down the seat bars
(B). You will hear a clicking sound. The
rollator is now locked in its open position.
Folding: Pull the strap on the seat (C) and
press the side frames together. Lock the
clamp (D) over the seat bars.
Carrying the rollator: The rollator must
not be carried by the seat strap or the
brake cables.
Fold the rollator together as shown on
the illustration (E). When folded, carry the
rollator by the seat bars (F).
4 Handles / Memory function
Height adjusting: Untighten the lock
wheel (A) (approx. 2 turns). Adjust the
handle tube to a suitable height then pull
it slightly up and down (C) until you hear a
clicking sound. Tighten the lock wheel (A).
Adjust both handles to the same height
by comparing the number scale on each
side. It is recommended that the handles are
set to the same height as your wrists when
your arms are hanging alongside your body.
Memory Function: Decide on the height
of the handles (see number scale). Count
visible holes at the back of the handle
tubes. Unscrew the lock wheel (A). Pull the
tube (B) out of the frame. The fastening
piece (D) will now follow the handle tube.
Move the fastening piece (D) so that the
number of holes above it equals to the
previously counted holes. Fit the red
memory chip (E) on the handle tube in
the first available hole under the fastening
piece (D). Push the handle tube (B) and
the fastening piece (D) downwards and
into the side frame (F). Screw the lock
wheel (A) halfway in. Pull the handle (G)
up until it stops, and then tighten the lock
wheel (A) properly. From now on, when
the handles are in the lowest position,
they will stop in the pre-set position when
pulled up.
Art. No. User Manual: 104840 – Rev. F, 2023-04
5 Brakes
Make sure the brakes are working before
each trip. Each brake lever (A) works on
each of the rear wheels. Do not drive or
push the rollator while the parking brakes
are activated.
Parking brakes: Push both brake levers
(A) downwards until they lock. Both rear
wheels are now locked. Squeeze both
brake levers upwards to release the park-
ing brakes.
Driving brakes: Pull both brake levers
(B) upwards to reduce speed. Do not use
continuously while the rollator is in motion.
Adjusting / checking: Loosen the nut
(C). Tighten the brake cable (D) with the
adjustment screw (E). Adjust both brake
blocks so the distance to the wheel sur-
face is approximately 1 mm (F) and then
tighten the nut (C). Make sure the brakes
are not adjusted too tight and pressing
hard into the rubber of the wheels when
the parking brake is on.
Maintaining: Clean the brake block (F)
and the brake spring (G) regularly. The
wheels and brakes can be replaced if they
are worn out or damaged.
6 Seat
The rollator has a safe and convenient
mesh seat, which provides view to the
ground while walking. It can easily be
wiped with a cloth if needed. The parking
brakes must be activated before using the
seat. Push both brake levers downwards
until they lock (A). Both rear wheels are
now locked. Sit with your back towards
the basket (B).
7 Edge guard / Tilt function
Edge guard: The edge guards (A), which
are in front of the rear wheels prevent
the rear wheels from catching on corners,
door frames etc.
Tilt function: To use the tilt function use
the front of the foot and press down on
the tilt pedal (B), which is beside the rear
wheel. This helps to tilt the rollator over
thresholds, edges etc. Please note: Be
careful when passing kerbs etc.
– 2 –
TOPRO Troja Original
Basket
The basket holds up to 10 kilos (model M
& S) / 5 kilos (model X). It can be removed
and washed gently at up to 60 °C.
Transport
The rollator should be transported in the
folded and locked position (see section
Unfolding / Folding). Ensure that the lock
clamp is on, so that the rollator cannot
unfold unintentionally. Be careful when
loading the rollator into a vehicle, giving
attention to securing it.
Storage
The rollator should be stored in an upright
position. If stored outdoors it must be
under a cover to protect it. Do not leave
your rollator unattended. Do not put
heavy items on top of the rollator during
storage.
Cleaning
The rollator can be cleaned using a damp
cloth. In case of mud and grime accumula-
tion, a cloth with a mild washing deter-
gent can be used followed by rinsing with
lukewarm water. Avoid flushing directly
against ball bearings (in wheels and front
forks). Do not use abrasives or steam
wash. Dry the rollator using a soft cloth.
When cleaning in automatic washing
systems the following applies: Washing; 60
°C, 10 min. (pressure maximum 4 bars, pH
neutral) – drying; 70 °C, 10 min.
Disinfection
Disinfection must only be carried out by
authorized personnel. Please contact your
local dealer or mobility aid centre. During
disinfection sufficient protective equip-
ment must be worn, and the instructions
of the disinfectant manufacturer must
be followed. The surface of the rollator
should be cleaned with a soft cloth or
sponge and an approved chemical disin-
fectant containing 70–80 % ethanol. We
advise against disinfectant that contains
chlorine or phenol. Do not use heat
disinfection. The manufacturer cannot be
held responsible for any damage or injuries
that might occur using harmful disinfect-
ant/measures or disinfection carried out by
unauthorized personnel.