Table of Contents
Advertisement
2. General Health & Safety Guidance
accessories and consumables.
• Do not use compressed air to clean the machine.
Always use a brush to dislodge dust in places that are
awkward to reach and a dust extractor to collect the
waste.
• Inspect electric cables periodically and, if damaged,
have them replaced by an authorised service facility or
qualified electrician.
• Inspect extension cables (if used) periodically and
replace if damaged.
28. Keep cutting tools sharp and clean
• Correctly maintained cutting tools are easier to control
and less likely to bind.
• Cutting tools and blades can become hot during use.
Take extreme care when handling them and always
allow them to cool before changing, adjusting or
sharpening them.
29. Disconnect the machine from the power
supply
• When not in use, before servicing, changing blades etc.
always disconnect the machine from the power supply.
30. Check for damaged parts
• Before each use of the machine, it should be carefully
checked to determine that it will operate properly and
perform its intended function.
• Check for alignment of moving parts, binding of
moving parts, breakage of parts and any other
conditions that may affect the operation of
the machine.
• A guard or other part that is damaged should be
properly repaired or replaced by a qualified person
unless otherwise indicated in this instruction manual.
• Do not use the machine if the switch does not turn the
machine 'ON' and 'OFF'.
• Have defective switches replaced by a qualified person.
31. Warning!
• The use of any accessory or attachment, other than
those recommended in this instruction manual, or
recommended by our Company may present a risk
of personal injury or damage to the machine and
invalidation of the warranty.
32. Have your machine repaired by a qualified
person
• This machine complies with the relevant safety rules
and standards appropriate to its type when used in
accordance with these instructions and with all of
the standard safety guards and equipment in place.
Only qualified persons using original spare parts
should carry out repairs. Failure to do this may result
in considerable danger to the user and invalidation of
warranty.
33. Caution! Motor may become hot during use
• It is normal for motors on some machines to become
hot to the touch during use. Avoid touching the motor
directly when in use.
7
Advertisement
Table of Contents
