Record Power SC1 Original Instruction Manual page 27

9. Maintenance
Re-Assembling the SC1
Important: When re-fitting the jaw slides, do
so in numerical ascending order in an anti-
clockwise direction.
Refit the jaw slides. They must be re-fitted in an anti-
clockwise direction in order for the scroll gear to register
i
correctly with the jaw slides. The slides do not have a
corresponding socket on the chuck body, so any socket
can be used to start from.
Before re-fitting the scroll gear, ensure the jaws are
symmetrically positioned as far inwards as possible as
shown in Fig 9.11.
With the chuck positioned face down, place the scroll
gear back into the chuck body and twist from side to side
until it drops into position, Fig 9.12.
Once the scroll gear is positioned correctly, check that
the jaw slides are still positioned symmetrically then refit
the circlip.
Fig 9.11
Fig 9.12
27