Abus FUMK50000W/B Installation Manual page 14

7. Training the zones
Ensure that the Secvest (receiver) is in learning mode.
Using a wireless accessory module (wireless
extension), hold the "SL" signal LED of the detector at a
maximum of 50 mm above the IR receiver. Train the
zones as described below.
The possible configurations of the individual
zones can be found on the previous pages. You
can also use this wireless magnet contact as a
wireless module.
8. Training zone 1
Keep the "TS2" anti-removal wall
contact pressed. When deinstalled,
also keep the "TS1" cover contact
pressed.
Open one of these contacts until
successful reception is confirmed.
9. Training zone 2
(if necessary)
Connect the "TAMP"
contact with a jumper on
the terminal connector
strip of contacts 4 and 5.
Open and close the
"TAMP" connection until
successful reception is
confirmed.
GB