Table of Contents
Advertisement
Never stop the wash dryer before the end of the drying cycle
•
unless all items are quickly removed and spread out so that the
heat is dissipated.
The final part of a wash dryer cycle occurs without heat (cool
•
down cycle) to ensure that the items are left at a temperature
that ensures that the items will not be damaged.
Do not use water spray and steam to clean the appliance.
•
Clean the appliance with a moist soft cloth. Only use neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Before maintenance, deactivate the appliance and disconnect
•
the mains plug from the mains socket.
SAFETY INSTRUCTIONS
INSTALLATION
•
Obey the installation instruction supplied with
the appliance.
•
Do not install or use the appliance where the
temperature is less than 0 °C or where it is
exposed to the weather.
•
Always move the appliance vertically.
•
Make sure that there is air circulation between
the appliance and the floor.
•
Remove all the packaging and the transit bolts.
•
Make sure that the floor where you install the
appliance is flat, stable, heat resistant and clean.
•
Keep the transit bolts. When you move the
appliance again you must block the drum.
•
Always be careful when you move the appliance
because it is heavy. Always wear safety gloves.
•
Do not install or use a damaged appliance.
•
Do not install or use the appliance where the
temperature is less than 0 °C or where it is
exposed to the weather.
•
Do not install the appliance where the appliance
door can not be fully opened.
•
Adjust the feet to have the necessary space
between the appliance and the carpet.
•
When the appliance is put in its permanent
position, check if it is fully level with the aid of a
spirit level. If it is not, adjust the feet until it is.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electrical
shock.
•
The appliance must be earthed.
4
•
Always use a correctly installed shockproof
socket.
•
Do not use multi-plug adapters and extension
cables.
•
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
•
Do not touch the mains cable or the mains plug
with wet hands.
•
Only for UK and Ireland: The appliance has a 13
amp mains plug. If it is necessary to change the
fuse in the mains plug, use a 13 amp ASTA (BS
1362) fuse.
•
This appliance complies with the E.E.C.
Directives.
WATER CONNECTION
•
Make sure not to cause damage to the water
hoses.
•
Before you connect the appliance to new pipes
or pipes not used for a long time, let the water
flow until it is clean.
•
The first time you use the appliance, make sure
that there is no leakage.
USE
WARNING! Risk of injury, electrical
shock, fire, burns or damage to the
appliance.
•
Use this appliance in a household only.
•
Do not change the specification of this
appliance.
Advertisement
Table of Contents
