Table of Contents
Advertisement
One Minute Beep
(NAM Option)
During conversation, you can be notified of the approxi-
mate talk time by tones for the first five minutes. (a
short monotone
signal will sound every minute and a
double beep tone will be heard after approximately 5
minutes.)
SID MANAGEMENT
(NAM OPTION)
This feature enables you (by NAM option) to take advan-
tage of a family of SID groups. This is a group of cellular
systems in cities that your carrier owns
or has special
billing arrangements with. Your close family SID's (like
brothers and sisters) will be billed at the same rate as
your home
bone Rilling PN will be indicated as "Home"
(i.e.
both
NOSVC| and ROAM!) are off) on your display. More
distant. family ve (like cousins) will be billed at a
preferred
rate. Your
phone will display solid
ROA
when using these groups of systems in their cities. When
flashing
is displayed, you are using a SID system
that is not included in the NAM
assigned groups.
If your display indicates flashing
, you will need
to change your A/B switch selection or, please refer to
Multiple City Registration to change phone registration
to enable you to make a call.
If in question as to what SID (system identification) you
are using, push ACK FA [8i to display the current SID.
A/B SYSTEM SELECTION
This feature permits you to select the system you need to
use. The system
that you are registered with is the
preferred system, and your home system.
1. Standard Mode
When you turn the unit on, the unit remembers the
last position of the A/B system selected, and will
start to scan
the radio frequency channels
of that
selection.
35
If you
want
to confirm
the current
mode,
press
[ENC, key [G. then
Status indicator shows the
current mode. To
return the unit to the standard
mode, press f
key [B] then IB] again.
Status
indicator shows SfE.
The unit will scan the pre-
ferred system channels.
If unable to find an accept-
able preferred channel, the unit switches to scan the
non-preferred channels.
2.
Preferred System € Only Mode
eR ENG, key '6! then [#1 Status indicator shows
The unit will scan the preferred system only
e) prevents switching over to the non-preferred
system.
3.
Non-preferred System Only Mode
Press FNC], key [0] then [8.. Status indicator shows
IN-PRE|. The unit will scan the non-preferred system
only.
4. Home Only Mode
x ENG, key [O then [21
Status indicator shows
Home. You can place or receive calls only within your
hone area.
MULTIPLE CITY
REGISTRATION
Some cellular users find it beneficial to register their
phone in multiple cities, rather than rely on "roam". The
multiple city registration feature permits you to repro-
gram from the telephone unit, the different phone num-
bers for the cities in which you are registered. Each
programmed phone number will be designated as your
home system.
Press CLA,
and enter the new
system ID number
(5
digits) followed by the corresponding phone number (10
digits). Please include your area code. You must register
your unit with the carrier in order to get both the system
ID number and your phone number.
Press
then key 6] Your new phone number will be
displayed on the readout.
(Holding down [6] to display
your new system ID number.)
Note:
(1) System ID number
and phone number can
not be programmed during a call.
(2)
Calls are placed or received using only the
programmed
phone number, in use at the
time of call.
36
Advertisement
Table of Contents
