Table of Contents
Advertisement
END-TO-END SIGNALING
This feature
permits you to utilize additional
phone
services, such as accessing an alternate long distance
network, signaling pager, or banking by phone etc..
For these services the signaling should be in DTMF
(Touch Tone™). The following two features will make it
easier to send in DTMF codes.
Note:
When you use this feature with a secret number,
the number must be previously stored in a memory
address. (Refer to "To Store the Secret Number")
Touch Tone?" from Memory
DTMF signaling by repertory dialing is available while
engaged in a telephone conversation.
1. Press ROE)
BEL, then enter the repertory memory
address (01 through 99).
The last 10 digits of the number will appear on the
readout.
Note:
However, if the memory address entered has
been set as a secret memory,
sk:
T]
will be displayed on the
sendout instead of the number.
2.
Press SEND]. Then
DTMF
signaling will be placed
and the DTMF
tone can be monitored through the
speaker.
Note:
Continuous DTMF from keypad can be manually
dialed as well to access answering machines when
engaged in a telephone call.
Link Dialing
This feature permits you to pre-set from repertory memory
or the keypad up to five numbers before placing a call.
With this feature, the first number is sent in digital form
to the cell site.
Then up to four other numbers
can be
sent with DTMF
signaling
by simply
pressing
for each additional number.
Note:
(1)
Each number to be linked may be recalled
from memory
or entered by keypad.
(2
Each number to be linked should be within 16
digits including linking mark "=" at the end.
(3)
Linked number can be stored in the memory.
However,
number
of more
than
16 digits
should
be stored into memory
address
96
through 99.
31
Example:
To access the alternate long distance service
using a secret number, you should call your
long distance
service
office first, and enter
your ID number, then the phone number
to
be placed.
1. Recall the phone number of the long distance service
office.
Press
REE,
then
enter
the
memory
address
(01
through 99).
2. Press [ENG], then key
B .
Linking Mark "=" will be added at the end of the
number and Lift will appear.
3.
Recall your ID number stored with secret attribution.
3-1.Enter the three-digit security code.
Press keys
2l
3 .
Note:
When
you recall the ID number
stored
without the secret attribution, omit the
step 3-1 and proceed to next step 3-2.
3-2. Recall the =
memory (ID number).
Press RCE), key [4] then [4 .
4.
Press
Press
then
enter
the memory
address (01
through 99) to recall the phone number to be ee.
RRS ER SS Be
»
6.
Press
SEND).
The INGWSE indicator will light a as iie
call is placed. Unk will appear on the readout,
—
7. After you received an answer from the long distance
service office, press
SEND: again.
The DTMF signal
will be placed and the DTMF tone of your ID number
can be monitored through the speaker.
Link 2! will appear on the readout.
32
Advertisement
Table of Contents
