Table of Contents
Advertisement
If your ID number
is accepted, the long distance
service office will answer again, so press SEND).
Then the long distance call will be placed and the
DTMF tone can be monitored through the speaker.
nka will appear on the readout.
Note:
The number linked in steps 1 through 5 can also
be stored in secret memory as stated in the "Se-
cret Memory".
1.
When a set of linked numbers which includes
a secret number has been stored in memory
address 96 through 99, enter the three-digit
security code, press
BEE,
memory
address
(96 through 99), and then
S E R [3 to place the
call.
WKT wil appear on the readout, and
the firs linked number
wil be called as
shown in step 6 above.
If the secret number is not included in the
linked number, you need not enter the three-
digit security code in the above operation.
2.
To complete the call, continue operations as
shown in the steps 7 and 8.
SCRATCH-PAD DIALING
This feature permits you to enter a number to be redialed
(or store
a number
in memory)
while
engaged
in a
conversation.
SCRATCH-PAD DIALING
WITHOUT KEYING
TONES
This feature permits you to activate scratch-pad memory
without annoying key tones over the circuit.
1.
Press [ENG], then key [8j then enter a phone number.
fone! will be displayed for 5 seconds. The Microphone
circuit will remain active, but the tones will not be
heard,
If necessary,
press BTO, then enter the memory
address.
i
To exit the Scratch-pad Mode, press ENG
again.
, then key
33
CALL TIME DISPLAY
This feature automatically records the elapsed time per
conversation. The talk time of the last call, cumulative
talk time, and the number of calls can be displayed on the
readout. The timers can also be cleared if necessary.
With beep tones you can be notified of the approximate
talk
time
(NAM
Option)
in approximately
60
seconds
increments.
To Display the Talk Time of the Last Call
1. Press RGL), key 3€ then EH .
The talk time of the last call will be displayed on the
readout for 5 seconds.
While in a conversation, the talk time of a call in
progress will be displayed, and updated each second.
The display format is as follows.
MnS)
. . . 1 min. and 25 sec.
To Display the Cumulative Talk Time
l. Press
Ll, key H then (2. .
The cumulative
talk time will be displayed on the
readout in minute format for 5 seconds.
HBmi
..18 min.
To Display the Number of Calls
1. Press BGH, key [H then 8 .
The number of calls will be displayed on the readout
for 5 seconds. The display format is as follows.
C
Received or placed 86 calls.
Outgoing Call Timer Only
(NAM Option)
Normal call timer operation is to time both the calls made
and the calls received. If the "outgoing call timer only"
function is activated (NAM
Option), the call timer will
only accumulate the number of calls and amount of time
when placing calls. It will not accumulate the number of
calls or amount of time for calls received.
To Clear the Timer
1. Press CLR, then enter the three-digit security code.
2. Press STO), key '* then [1].
The
timers
will be cleared,
and
the count
for the
cumulative talk time and the number of calls will start
from zero.
34
Advertisement
Table of Contents
