Sony BRAVIA XR65X95LU Manual page 81

1
After connecting the TV to your audio system, press the
button on the remote control, then select [Settings] — [Display & Sound] —
[Audio output] — [Speakers] — [Audio system].
2
Turn on the connected audio system, then adjust the volume.
If you connect a BRAVIA Sync-compatible device with an HDMI connection, you can
operate it by simply using the TV's remote control.
Note
You need to configure the [Digital audio out] settings according to your audio system.
Press the (Quick Settings) button on the remote control, then select [Settings] —
[Display & Sound] — [Audio output] — [Digital audio out].
If the audio system is not compatible with Dolby Digital or DTS, set [Settings] —
[Display & Sound] — [Audio output] — [Digital audio out] to [PCM].
The [Digital audio out] settings are disabled when using audio signals that are passed
through from the HDMI input and using eARC.
Hint
If a specific audio system is connected with an HDMI cable, you can adjust the output
timing of the picture and sound.
Adjusting the AV sync setting
For details about supported models, refer to the support site.
Support Site
Related topics
BRAVIA Sync-compatible devices
Connecting an audio system
No sound but good picture.
No audio or low audio with a home theatre system.
[69] Audio system (such as an AV receiver or sound bar) | Audio system (such as an AV
receiver or sound bar)
Using the TV as a centre speaker (only models with
TV centre speaker mode)
(Quick Settings)