Setting The Clock - Aiwa CT-X409 Operating Instructions Manual

SETTING THE BEEP TOME SETTING THE CLOCK
The unit is preset at the factory to beep each time
you press any button on the front panel except 1,,
-4M and You can stop beeping by
following the procedure below.
1 With the unit off, press 1 and 4 at the
same time.
The "BEEP" indication appears.
Each time you press them, this function turns
The beep function is activated when the
"BEEP" indication appears with the audio
control indicator lighting up and canceled
without the indicator.
I fff FF
1 Press PWR to turn the unit on.
2
Press and hold DISP for more than 2
seconds until the clock indication
If you do not proceed with step 3 within 5
seconds, the clock indication disappears.
3
Press TUNE T to set the hour.
Press TUNE k to set the minute.
4
Press DISP to start working the clock
from 0 second.
Audio control indicator
Having the clock displayed while in Radio or
Tape Play mode
Press DISP. The clock display appears for 5
seconds, then the unit returns to its former display.