Page 1
TE-AC 430/90/10 Originalbetriebsanleitung Manual de instrucciones original Kompressor Compresor Original operating instructions Alkuperäiskäyttöohje Compressor Kompressori Instructions d’origine Originalna navodila za uporabo Compresseur Kompresor Istruzioni per l’uso originali Eredeti használati utasítás Compressore Kompresszor Original betjeningsvejledning Instrucţiuni de utilizare originale Kompressor Compresor Original-bruksanvisning Πρωτότυπες...
Page 6
Warning - Read the operating instructions to reduce the risk of inquiry Warning! Wear ear-muff s. The impact of noise can cause damage to hearing. Warning of electrical voltage! Warning of hot parts! Warning! The unit will start up automatically without warning if the pressure drops below cut-in pressu- Notice! Before using for the ...
13. Quick-lock coupling (unregulated com- Danger! When using the equipment, a few safety pre- pressed air) cautions must be observed to avoid injuries and 14. Oil sealing plug damage. Please read the complete operating 15. Oil drainage screw instructions and safety regulations with due care. 16.
• Spring washer (4x) Wear ear-muff s. • Nut for fitting the axle (2x) The impact of noise can cause damage to hea- • Hexagon screw (2x) ring. • Original operating instructions • Safety information 5. Before starting the equipment 3.
6. Assembly and starting 6.8 Adjusting the pressure: (Fig. 1,2) • You can adjust the pressure on the pressure gauge (6) using the pressure regulator (7). Notice! • The set pressure can be taken from the quick- You must fully assemble the appliance before lock coupling (5).
Page 10
• You must disconnect the hose and any Then replace the oil sealing plug (14). spraying tools from the compressor before cleaning. Do not clean the compressor with 8.6 Cleaning the intake lter (1) water, solvents or the like. The intake ...
10. Possible causes of failure Problem Cause Solution The compressor 1. No supply voltage. 1. Check the supply voltage, the pow- does not start. er plug and the socket-outlet. 2. Insuffi cient supply voltage. 2. Make sure that the extension cable is not too long.
* Not necessarily included in the scope of delivery! In the eff ect of defects or faults, please register the problem on the internet at www.Einhell-Service.com. Please ensure that you provide a precise description of the problem and answer the following questions in all cases: •...
Page 14
5. To make a claim under the guarantee, please register the defective device at: www.Einhell-Service.com. Please keep your bill of purchase or other proof of purchase for the new device. Devices that are returned without proof of purchase or without a rating plate shall not be covered by the guarantee, because appropriate identi...
Need help?
Do you have a question about the TE-AC 430/90/10 and is the answer not in the manual?
Questions and answers