Table of Contents
Advertisement
Quick Links
D
Originalbetriebsanleitung
Kompressor
GB
Original operating instructions
Compressor
F
Instructions d'origine
Compresseur
I
Istruzioni per l'uso originali
Compressore
CZ
Originální návod k obsluze
Kompresor
SK
Originálny návod na obsluhu
Kompresor
NL
Originele handleiding
Compressor
E
Manual de instrucciones original
Compresor
SLO
Originalna navodila za uporabo
Kompresor
H
Eredeti használati utasítás
Kompresszor
RO
Instrucţiuni de utilizare originale
Compresor
9
Art.-Nr.: 40.206.00
Anl_TE_AC_6_Silent_SPK9.indb 1
TE-AC 6 Silent
I.-Nr.: 11018
08.04.2019 13:58:52
Advertisement
Table of Contents
Related Manuals for EINHELL TE-AC 6 Silent
Summary of Contents for EINHELL TE-AC 6 Silent
- Page 1 TE-AC 6 Silent Originalbetriebsanleitung Kompressor Original operating instructions Compressor Instructions d’origine Compresseur Istruzioni per l’uso originali Compressore Originální návod k obsluze Kompresor Originálny návod na obsluhu Kompresor Originele handleiding Compressor Manual de instrucciones original Compresor Originalna navodila za uporabo Kompresor Eredeti használati utasítás...
- Page 2 - 3 -...
- Page 3 - 4 -...
- Page 4 Warning! - Read the operating instructions to reduce the risk of inquiry Warning! Wear ear-muff s. The impact of noise can cause damage to hearing. Beware of electrical voltage! Beware of hot parts! Warning! The equipment is remote-controlled and may start-up without warning. PS: 8 bar : -10°C : +100°C...
-
Page 5: Safety Regulations
Danger! 2.2 Items supplied When using the equipment, a few safety pre- Please check that the article is complete as cautions must be observed to avoid injuries and speci ed in the scope of delivery. If parts are damage. Please read the complete operating missing, please contact our service center or the instructions and safety regulations with due care. -
Page 6: Technical Data
• 4. Technical data Operate the equipment only on a firm, level surface. • Use flexible hoses in order to prevent trans- Mains connection: ....220-240 V ~ 50 Hz mitting unacceptable loads to the pipeline Motor rating: ..........550 W system at the connection between the com- Compressor speed min : ...... -
Page 7: Replacing The Power Cable
6.4 Setting the pressure (Fig. 1,2) re that no water can seep into the device. The • You can adjust the pressure on the pressure ingress of water into an electric tool increases gauge (6) using the pressure regulator (7). the risk of an electric shock. -
Page 8: Disposal And Recycling
8.6 Transport • Transport the equipment only by carrying it by the transport handle. • Protect the equipment against unexpected knocks and vibrations. For EU countries only Never place any electric power tools in your 8.7 Ordering replacement parts: Please quote the following data when ordering household refuse. -
Page 9: Possible Causes Of Failure
10. Possible causes of failure Problem Cause Solution The compressor 1. No supply voltage. 1. Check the supply voltage, the pow- does not start. er plug and the socket-outlet. 2. Insuffi cient supply voltage. 2. Make sure that the extension cable is not too long. -
Page 10: Service Information
Service information We have competent service partners in all countries named on the guarantee certi cate whose contact details can also be found on the guarantee certi cate. These partners will help you with all service re- quests such as repairs, spare and wearing part orders or the purchase of consumables. Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also required for use as consumables. - Page 11 Warranty certi cate Dear Customer, All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card.