SIMPLE PROGRAMMABLE EDIT (The edit remote control is optional)_
Simple programmable edit allows you to programme your camera/recorder to select the scenes you
want to copy from a pre-recorded tape. Use the edit remote control (optional) to easily copy scenes from
a recorded tape in the camera/recorder (playback machine) onto a blank tape in a table-top VCR which
handles infrared remote signals (recording machine).
NOTES
• Only the VM-RM20EDE edit remote control (optional) can be used with this camera/recorder.
• Some VCRs cannot be operated by the edit remote control (optional).
Source
tape
Copied
tape
Start
End
Start
End
Start
End
point
point
point
point
point
point
PROG. 1
PROG. 2
PROG. 3
■ How to install the batteries
•
Do not use the old and new batteries at the
same time.
• Do not mix batteries of different types.
• Do not short, take apart or dispose of batteries
by throwing them into a fire.
• When liquid leaks, wipe it off completely and
then insert new batteries.
■ Remote controllable range
Cautions on the remote control
•
Point the remote control straight at the VCR's
infrared receiver for operation.
•
Use the remote control indoors. When the
infrared receivers of the VCR and camera/
recorder are exposed to direct sunlight or
strong artificial light, the remote control may
not operate correctly.
• The remote control cannot be operated if there
is an obstacle between the remote control and
infrared receiver. Especially, be careful of this
during dubbing.
38