Video Channel Setting.36 - Hitachi VM-E543LE Instruction Manual

Example 2: If your TV is a regular TV,
RF output adaptor.
2. Connect the Aerial cable to "OUT TO TV" on
the RF output adaptor.
3. Connect the other end to aerial terminal on
your TV.
4. Connect the connector cable from RF output
adaptor to audio/video output jack on the
camera/recorder.
below.
6. Perform same procedures in steps 3 through 6
of "Example 1" on page 35.
NOTES:
• With this connection, the output sound is
monaural.
• With some TVs, audio noise may be heard dur¬
ing forward/reverse search and during still
playback.
NOTE: If you want to watch a TV programme with camera/recorder connected as illustrated, slide
the CAM/OFFVIDEO switch of the camera/recorder to "OFF".
VIDEO CHANNEL SETTING
When viewing the picture played back by the camera/recorder on your TV, change over the l/G select
switch of the RF output adaptor matching your TV as well as to select the video channel on the TV.
1. Connect TV, RF output adaptor and camera/
recorder. (See above)
2. Set l/G select switch on RF output adaptor as
follows.
Colour TV broadcast system
in your country
Position of l/G
Select Switch
PAL (System 1)
1
PAL (System B & G)
G
3. Turn on TV and select an unused channel
(CH37). (In some cases this may be marked
A/V.)
4. Insert the recorded tape to camera/recorder.
5. Slide the CAM/OFFA/IDEO switch to "VIDEO".
6. Press the PLAY button of camera/recorder.
Now playback picture appears on your TV.
If the playback picture is not clear or channel
37 is used for broadcasting in your area, adjust
the RF output control of RF output adaptor
using a small screwdriver and readjust your
TV until the playback picture is clearly
observed.
l/G Select Switch
36