Power Sources.11 - Hitachi VM-E543LE Instruction Manual

POWER SOURCES
NOTE: Be sure to turn off power of the camera/recorder when attaching or detaching a power
supply (battery, AC adaptor/charger, etc.) to the camera/recorder.
■ WHEN USING WITH BATTERY (provided)
NOTE: The battery must be charged before it can be used for the first time. Refer to "CHARGING THE
BATTERY" on page 13.
Mark
k-
1. Align the bottom of the battery with mark ►
on the camera/recorder so that the battery fits
into the grooves.
2. Slide the battery downward, as illustrated.
NOTES:
• Always remove the battery from the camera/
recorder after use.
• We cannot guarantee against malfunctions of
the camera/recorder which occur when you
use battery packs other than those specified.
• Always attach a battery by the procedure
described here. Attaching a battery forcibly
could damage it.
■ Removing the battery pack
Slide the BATTERY EJECT lever in the direction of
the arrow and hold it, then slide the battery to the
upper side and remove.
■ WHEN USING WITH THE AC ADAPTOR/CHARGER (provided)
1. Connect one end of the DC cord (provided) to
the camera/recorder as shown in the figure.
2. Connect the other end of the DC cord to the DC
OUT jack of the AC adaptor/charger.
3. Plug the AC adaptor/charger power cord into
an AC electrical outlet.
4. After the AC adaptor/charger has been used,
unplug its power cord from the AC outlet.
See the bottom of the AC adaptor/charger.
The rating label is located on the bottom of
the AC adaptor/charger.
NOTES:
• This AC adaptor/charger is universal for use
with AC 110 — 240V around the world. If you
use the camera/recorder in some foreign
countries, an AC plug adaptor (Not supplied)
may be necessary.
• The AC adaptor/charger cannot charge the bat¬
tery and operate the camera/recorder at the
same time.
Remove the battery from the AC adaptor/
charger to supply power to the camera/
recorder.
11