Table of Contents
Advertisement
Step No.
Configuring MPE
Prompt and Response
After you respond to all the prompts for one device, this
LOGICAL DEVICE #?
prompt
is repeated to allow for configuring additional devices. If I/O configuration is
complete, press
(RETURN]
and the system configuration dialogue continues with step 46.
9
DRT #?
o
Removes the device specified in the previous
prompt from the current MPE configuration.
xx
10
UNIT #? 0
11
SOFTWARE CHANNEL #?
0
12
TYPE? 17
13
SUBTYPE?
o
or 1
Enters the hardware DRT number for the INP.
(RJE and MRJE)
(IMF)
(OS)
(x.
25)
o
= Synchronous switched line with a modem
1
=
Synchronous nonswitched line with a modem
2
= PAD printer with attached HP2334A
3
=
Synchronous nonswitched line, hardwired
(Note: If the INP is hardwired directly to an SSLC, always configure both the INP and
the SSLC as Subtype 1 and Transmission Mode
1.)
16
17
RECEIVE TIMEOUT?
2.-32000 or
(RETURN]
(RETURN]
LOCAL TIMEOUT?
2.-32000 or
(RETURN]
(RETURNl
(20-second default)
(OS, IMF, RJE, and X.25)
(MRJE overrides this option)
(60-second default)
(OS, IMF, and RIE)
(MRJE overrides this option)
(x.
25 does not use this response)
A-3
Advertisement
Table of Contents
Troubleshooting
