Bosch EasyLevel Original Instructions Manual page 31

point. Apply or check the height difference measured at
the target location.
Checking Horizontal/Vertical Lines with the Spirit
Levels (see figure G)
The measuring tool can also be used as a carpenter's spirit
level for checking vertical and horizontal lines, for example
to align a washing machine or a refrigerator. Position the
measuring tool with the aluminium supporting surface (2)
on the surface to be checked.
When placing on horizontal surfaces, the aluminium sup-
porting surface (2) must face downward; when placing
against vertical surfaces, the laser outlet aperture for line
operation (5) must face upward.
Working Advice
Only the centre of the laser point or laser line must
u
be used for marking. The size of the laser point/the
width of the laser line changes depending on the dis-
tance.
Fastening/Aligning using the Holder
Using the holder (14), the measuring tool can be fastened
as follows:
– Line operation: Hanging it by the recess on its rear,
place the holder onto a screw head slightly projecting
out of a wall. Use the magnets (9) to fasten the measur-
ing tool to the metal surface for line operation (15) of
the holder. Turn the upper part of the holder to align the
measuring tool as required.
– Point operation: Using the tripod mount (18), place
the holder onto the 1/4" thread of the tripod and screw
it tight using the locking screw of the tripod. Align the
tripod roughly. When working without a tripod, place
the holder (14) on a surface that is as level as possible.
Bosch Power Tools
English | 31
1 609 92A 8KK | (24.02.2023)