Technical Data - Helios KWL-KP I Installation And Operating Instructions Manual

Installation and Operating Instructions
NOTE
NOTE
ATTENTION
CHAPTER 2

TECHNICAL DATA

NOTE
Condensate pump KWL-KP-I
1.6 Storage
When storing for a prolonged time the following steps are to be taken to avoid damaging
influences:
Protection by dry, air- dustproof packing (plastic bags with drying agent and moisture
indicators). The storage place must be waterproof, vibration-free and free of excessive
temperature variations (0 to +40 °C). Damages due to improper transportation, storage
or commissioning are verifiable and not liable for warranty.
1.7 Intended use
Condensate that accumulates in the ventilation unit due to heat recovery can be drained with
the condensate pump KWL-KP-I.
The condensate pump KWL-KP-I can be connected to KWL ventilation.
In order to be able to use the pump in KWL units, a sufficiently large condensate tray is
required. (See switch-on and switch-off heights in Fig.4)
KWL-KP-I is a completely sealed submersible condensate pump for unit-integrated use
in the condensate tray.
The condensate pump KWL-KP-I may only be used indoors and with clean water up
to max. + 25°C. It is not intended for use under water.
Any use other than the intended use is prohibited!
2.1 Technical data
KWL-KP-I
Flow rate max.
Suction head max.
Discharge head max.
Ambient temperature
Water temperature max.
Material
Voltage
Frequency
Power supply
Protection category
Alarm relay
Dimensions
Cable length
Weight
The condensate pump KWL-KP-I requires a condensate hose (provided by custo-
mer) with an internal diameter of 5 - 6 mm.
12 l/h
1 m
20 m
0-40 °C
+ 25 °C
ABS piston pump
230 V
50/60 Hz
16 W
IP68
5 A, 30 VDC, 250 VAC, NC
43 x 34 x 160 mm (B x H x L)
2 m
470 g
2
EN