Advertisement
The Advantage One 1x6 charger saves pre-defined settings in its memory, so you can use them
later for your favorite batteries.
1. Select Save Data using the BATTERY TYPE button.
2. When you are on Save Data, press START to confirm.
3. Use the + and - buttons to select the charging program number and press START to confirm.
4. Select the battery type and confirm with START.
5. Select voltage, confirm with START.
6. Select your battery capacity, confirm with START.
7. Press START for two seconds to save to memory.
8. To use a stored setting, select Load Data using the BATTERY TYPE button.
9. Select the memorized setting with + and - and confirm by pressing START for two seconds.
The Advantage One 1x6 charger allows you to change the default settings, but this should only be
done by experienced personnel.
1. Select User Set using the BATTERY TYPE button.
2. When you are on User Set, press START to confirm.
3. Use the + and - buttons to select the setting to be changed, then press START. It will flash,
select the desired setting with + and -, confirm with START.
4. Some values cannot be set for safety reasons.
5. The Capacity Cut-Off parameter allows you to select the maximum capacity to be charged,
once reached the charger will stop charging.
6. The Safety Timer parameter allows you to select the maximum charging time, once reached
the charger will stop charging.
7. The Key Beep and Buzzer parameters can be used to deactivate sounds.
We recommend charging batteries at 1C (once their capacity).
500 mAh battery
1000 mAh battery
2400 mAh battery
3000 mAh battery
4000 mAh battery
5000 mAh battery
8000 mAh battery
Save a setting
Advanced settings
Charging tips
0,5 A
1,0 A
2,4 A
3,0 A
4,0 A
5,0 A
5,0 A
Advertisement
