3. Balancing adapter port 1 7. Temperature probe port 2 - Menu 2S LiPo battery with 2S LiPo battery with 4mm 4. Charge output 1 - Channel Deans and XH connectors and 2mm gold tubes connectors Team Orion Advantage Twin Spec www.teamorion.com...
Introduction Power Source Thank you for choosing Team Orion’s Advantage Connect the charger to a stable 10-25VDC power source, Twin Spec charger. This charger can independently respecting the polarities, red is positive (+) and black and simultaneously charge or discharge two batteries.
Battery capacity Charging current Delta peak setting or balancing ON/OFF (depending on the type of battery selected) 2S LiPo battery with 2S LiPo battery with 4mm Deans and HX connectors and 2mm gold tubes connectors Team Orion Advantage Twin Spec www.teamorion.com...
Always follow the manufacturer’s charge recommendations. CHANNEL (CH) key: Selects the charge output, left (1) or right (2) Note: make sure you are adjusting the settings for the correct channel you wish to use. Team Orion Advantage Twin Spec www.teamorion.com...
Page 7
The maximum possible charge current is calculated using various factors such as battery type, power supply and parameters in advanced settings. The default maximum charger power is 250W for each channel and up to 350W for a single channel after using the power share. Team Orion Advantage Twin Spec www.teamorion.com...
Note: Depending on the conditions of use, the charger thermal protection might activate so that underlying risks and you are certain the battery is fully functional. the charger can cool down. After a brief interruption the charge will resume and continue normally. Team Orion Advantage Twin Spec www.teamorion.com...
This charge will be interrupted after 20 minutes or when you return to the main charge screen. Warning! If you press the ENTER key too long, the discharge will start with the actual settings. Team Orion Advantage Twin Spec www.teamorion.com...
A battery average discharge voltage indicates the power output of the battery at a determined di- scharge rate. A battery with a higher value will be more powerful than a battery with a lower value (if tested and used in the same conditions). Team Orion Advantage Twin Spec www.teamorion.com...
2. Number of cycles selection, from 1 to 15 actual settings. After you have selected the cycling mode, press and hold the ENTER key. The battery check will be displayed. Team Orion Advantage Twin Spec www.teamorion.com...
Page 12
“CYCLE COMPLETE” message is displayed”. Note: depending on the conditions of use, the charger thermal protection might activate so that the charger can cool down. After a brief interruption the charge or discharge will resume and continue normally. Team Orion Advantage Twin Spec www.teamorion.com...
Note: depending on the conditions of use, the thermal protection might activate so that the charger to 3.85V/cell for LiPo and 3.3V/cell for LiFe. can cool down. After a brief interruption the charge/discharge will resume and continue normally. Team Orion Advantage Twin Spec www.teamorion.com...
(for example the 8.40V limit for 2S LiPo). battery to cool between the cycles. The range is 0 – 60 minutes. The range is 3.2 – 4.25V/cell for LiPo, 3 – 3.80V/cell for LiFe, 1 – 2V/cell for NiMH/NiCd. Team Orion Advantage Twin Spec www.teamorion.com...
ENTER key. This screen displays the cycle end data. charged and discharged capacity. By pressing ENTER and using the + and – keys you can cycle through the various cycles results. Press MENU to exit. Team Orion Advantage Twin Spec www.teamorion.com...
Internal temperature Indicates the actual charger’s internal temperature. Indicates a connection problem with your battery. Check that the battery is connected and functional. Battery temperature Indicates the actual battery temperature (using optional temperature probe). Team Orion Advantage Twin Spec www.teamorion.com...
Check that the balancing connector is properly connected. Indicates that the charger is overheating. Wait for the charger to cool down and resume function, modify your settings (lower charge or discharge amps) or relocate, ventilate the charger to improve cooling. Team Orion Advantage Twin Spec www.teamorion.com...
Warranty Specifications Team Orion guarantees this product to be free from manufacturing and workmanship defects. The Microprocessor controlled dual-output charger for NiMh/NiCd/LiPo/LiFe batteries warranty does not cover incorrect installation, components worn by use, or any other problem resulting Input voltage 10-25V DC (25V necessary for high current high voltage battery charging) from incorrect use or handling of the product.