Diagrams And Replaceable Parts; General - HP 8082A Operating And Service Manual

INTRODUCTION
This section contains the circuits, comoonent
location diagrams and the lists of replaceable parts.
Waveforms shown with the circuits are included for
only and failure to observe identical results
should not be automaticaily
fault. Tables 6-7 and 6-2 provide information relating
to the replaceable parts lists and the circuit diagrams.

General

6 - 5 The replaceable parts tables list parts in
alpha-numerical order of their reference designators and
indicate the description and HP stock number of each
part, together with any applicable notes.
6 - 6 To order a replacement part, address order
or enquiry either to your authorized Hewlett-Packard
A = assembry
B = motor
B T = battery
= capacitor
C
= coupler
C R
= delay line
DL
= lamp
= fuse
F L = filter
= heater
= jack/connector
K = relay
= inducer
M
taken as indication of a
= micro-circuit
U
P = pklg
= transistor
Q
= resistor
R T = thermistor
= switch
= transformer
= terminal board
T B
= test point
T P
= vacuum, tube, neon
V
VR = voltage regutator
= cables
W
= crystal
DIAGRAMS AND REPtACEAi3LE PARTS
sales representative or to:
CUSTOMER SERVICE
Hewlett-Packard
333 Logue Avenue,
Mountain View, California 94040
or, in Western Europe, to:
Hewlett-Packard (?%hweizf SA
Rue du Boisdu-Lan 7
Geneva
6 - 7 Specify the following information for each
part:
Model and compiete
ment.
Hewlett-Packard stock number.
Circuit reference stock number.
Description
To order a part not listed, give a complete description
of the part and include its function and location.
Table 6-1. Component Designators
Components mounted on an assembly are identified by
prefixing the component reference designator by the
assembly designator. Thus, for example, A4CRB is diode
Designators of components mounted on the frame
receive no prefix.
Company,
serial number of instru-