Table of Contents
Advertisement
*Non applicable to the ULTRASONIC NMEA 2000 model.
Upgradable via RS485, MODBUS ,
3.8. Firmware
or UART/TTL
3.9 Product Material
The ULP STD is engineered to be a robust
device with
minimal downtime. This new shape has been
designed for optimum water spillage which
implies
lower probability of ice formation. Frost might
affect measurements if it blocks the wave path.
The input wires are protected by Transient
Voltage
Suppression (TVS) diodes. The instrument
body is built with Polyamide.
3.10 Quality Control
Every single unit is calibrated with accuracy,
following the same calibration standards for
each one in a wind tunnel.
A Q/C report for both wind speed and direction
is generated and kept in our files. Standard
deviation is checked to guarantee that each unit
has been calibrated to the highest standards.
4. Firmware
Firmware upgradable. Configurable via cable
using the configuratior ( https://calypsoinstru-
ments.com/technical-information). A USB
converter cable is available as an accessory on
calypsoinstruments.com.
ULP STD
NEW!
User manual
5. Configuration Options
The ULP STD can be set up by using a special
configuration app made by Calypso Instru-
ments.
In order to use the app, you should download the
configurator from our website at
www.calypsoinstruments.com.
To configure your device, connect the ULP via
either a USB to RS485 converter cable (in case
of the ULP RS485 or the ULP Modbus) or via a
USB to UART converter cable (in case of the ULP
UART). Connect all the ULP cables except for the
brown cable to the converter. Insert the USB into
the computer, open the configurator app, select
the configuration wanted and follow the instruc-
tions on the screen to finish the configuration.
For more information, please watch the
following video.
https://bit.ly/3DuA7lM
*USB converter cables available on calypsoins-
truments.com.
This is how the App looks in every step:
1º When you open the Configurator
06/14
Advertisement
Table of Contents
