.
A. ON/OFF switch
B. Weld jack socket
C. Argon inlet
1. Using a suitable connector fused at 5 amps, connect to mains
supply.
2. If Argon is to be utilised, couple argon hose to rear of welder.
Do not over-tighten as a good seal will be made with the nut
slightly more than finger tight.
3. Connect free end of argon hose to the argon supply via an argon
flow regulator.
4. Switch on.
5. Hold welding mode switch in "purge" position and adjust argon
flow to 8 litres per min.
The apparatus is now ready for use.
Rear Panel Controls
Power to instrument ON/OFF
Footswitch connection
For connection to Argon supply.
Setting Up
- 6 -