Storage; Storing The Snowthrower - Toro Power Clear 721 R-C Operator's Manual

Commercial snowthrower
Hide thumbs Also See for Power Clear 721 R-C:
Table of Contents

Advertisement

Storage

Storing the Snowthrower

WARNING
• Gasoline fumes are highly flammable, explosive,
and dangerous if inhaled. If you store the
machine in an area with an open flame, the
gasoline fumes may ignite and cause an
explosion.
• Do not store the machine in a house (living
area), basement, or any other area where ignition
sources may be present, such as hot water and
space heaters, clothes dryers, furnaces, and
other like appliances.
• Do not tip the machine backward with fuel in
the fuel tank; otherwise, fuel may leak out of
the machine.
1. On the last refueling of the season, add fuel stabilizer
to fresh fuel as directed by the engine manufacturer.
2. Run the engine for 10 minutes to distribute the
conditioned fuel through the fuel system.
3. Stop the engine, allow it to cool, and siphon the fuel
tank or run the engine until it stops.
4. Start the engine and run it until it stops.
5. Choke or prime the engine, start it a third time, and
run the engine until it will not start.
6. Drain the fuel in the carburetor through the carburetor
drain bolt
(Figure
33) into an approved gasoline
container.
7. Dispose of unused fuel properly. Recycle it according
to local codes, or use it in your automobile.
8. While the engine is still warm, change the engine oil.
Refer to
Changing the Engine Oil (page
9. Remove the spark plug.
10. Squirt 2 teaspoons of oil into the spark plug hole.
11. Install the spark plug by hand and then torque it to 27
to 30 N-m (20 to 22 ft-lb).
12. With the ignition key in the Off position, pull the recoil
starter slowly to distribute the oil on the inside of the
cylinder.
13. Clean the machine.
14. Touch up chipped surfaces with paint available from an
Authorized Service Dealer. Sand affected areas before
painting, and use a rust preventative to prevent the
metal parts from rusting.
15. Tighten any loose fasteners. Repair or replace any
damaged parts.
16. Cover the machine and store it in a clean, dry place
out of the reach of children. Allow the engine to cool
before storing it in any enclosure.
15).
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

38751

Table of Contents